Normalmente, un pozo productor de hidrocarburos emplea el 99% de su vida productiva operando bajo el regimen de estado pseudoestable y continua su operacion mientras se ejecutan pruebas de interfe- rencia en otros pozos dentro del mismo campo. Esto ocasiona que la estimacion de parametros utilizando datos recogidos durante una prueba de interferencia, en la cual los pozos involucrados se asumen unicos dentro de un yacimiento infinito, puede no ser muy precisa, en virtud a que la produccion de pozos vecinos dentro del mismo yacimiento puede ocasionar una caida de presion adicional, que afectara la presion inicial y la medida durante la prueba, haciendo que su interpretacion no sea adecuada. En este articulo se presenta un metodo para corregir o extrapolar la presion aplicando el principio de superposicion, incluyendo la declinacion de la presion causada por pozos vecinos en produccion, al modelamiento tradicional para pruebas de interferencia. El analisis e interpretacion de los datos obteni- dos son realizados con la novedosa tecnica Sintesis Directa de Tiab, que analiza el comportamiento de los datos de presion y su derivada, sin el uso de curvas tipo. Si la derivada de la presion se calcula de manera apropiada y esta se define satisfactoriamente, la tecnica permite estimar directamente los parametros del yacimiento con bastante precision mediante puntos caracteristicos, ya que usa solucio- nes analiticas. Al hallar la derivada a partir de los datos tomados directamente de la prueba, la curva resultante no se definira apropiadamente y los parametros estimados pueden presentar errores. El contraste entre los resultados determinados en la interpretacion de los datos tomados de la prueba y los corregidos median- te el principio de superposicion, se ilustra con dos ejemplos sinteticos. Abstract Normally, a hydrocarbon well spends 99% of its productive life under pseudosteady state flow regime and continues operating while conducting interference test on other wells inside the same field. This probably causes inaccuracy in the estimation of parameters using recorded raw data during the interference test, in which the involved wells are considered unique inside an infinite reservoir. The production of neighboring wells inside the same reservoir can cause additional pressure drops, which affect the initial and measure pressure during the test, leading to a possible misinterpretation of the pressure test. In this article a method is presented to either correct or extrapolate the pressure by applying the superposition principle, including the pressure decline caused by production of neighboring wells on the traditional modeling for interference testing. The analysis and interpretation of the data recorded is carried out by means of Tiab Direct Synthesis Technique, TDS technique, which analyzes the behavior of the pressure and pressure derivative data, without using type-curve matching. If the pressure derivative is properly calculated and successfully defined, the technique allows us to estimate the reservoir parameters directly with enough precision through characteristic points, using analytic solutions. If pressure derivative is calculated employing directly the raw recorded data, the resulting curve will not be properly defined and the estimation of parameters may be inaccurate. A comparison of the results from the interpretation of the raw data and the corrected/extrapolated by the application of the superposition principle is illustrated with two synthetic examples.