En este articulo se reportan los resultados de la operacion y evaluacion de un clarificador de manto de lodos de suspension hidraulica a escala de laboratorio a partir de un diseno de experimentos factorial 23, en el cual se utilizaron la turbiedad del agua cruda, la carga hidraulica o tasa superficial y el tipo de coagulante como factores que podian afectar la formacion del manto y, por consiguiente, la eficiencia del sistema en la remocion de la turbiedad del agua. Se emplearon dos tipos de coagulante: sulfato de aluminio y C-235 (polimero cationico) y se estudiaron dos diferentes tipos de agua cruda (sintetica) preparadas en el laboratorio con la adicion de caolin, la primera con alta turbiedad (Tipo I con 100 UNT) y la segunda con baja turbiedad (Tipo II con 15 UNT). El sistema fue operado con tasas superficiales de 35 y 70 m3/m2.dia. Los resultados obtenidos permiten establecer que cuando el sistema se opero con agua Tipo I y una carga hidraulica de 70 m3/m2.dia se genero el manto de mejores caracteristicas y la turbiedad en el efluente alcanzo valores por debajo de 2 UNT. Abstract: In this paper, we report the results for the operation and performance of a laboratory-scale clarifier sludge blanket suspension hydraulic, through a series of experiments that used a 23factorial design. Factors in the design included: turbidity of raw water, hydraulic load rate and type of coagulant. These factors could affect the formation of a blanket, and therefore, the system’s efficiency on the removing turbidity. Two types of coagulants –aluminum sulfate and C-325 (a cationic polymer)– were tested in two types of synthetic raw water prepared in the laboratory through the addition of kaolin with high (Type I with 100 NTU) and low (Type II with 15 NTU) turbidity. The system was operated with surface load rates of 30 and 70 m3/m2.day. Results show that the best blanket was generated when the system was operated with Type I water and a hydraulic load rate of 70 m3/ m2day, with turbidity values in the effluent below 2 NTU.